The graph on the 1st site of that subject matter need to persuade you that Alliant 410 isn't the powder to employ with AA-HS hulls.



Never learn about 410, but, I bumped into a similar detail with Alliant e3. I began shooting it in .40 S&W and perhaps sent exam loads to Alliant for force tests with very good effects.

This really is kinda "Innovative reloading 101" and can be done once you have a grasp of what is going on firstly degree.

You can find not released load data readily available for this powder for anything apart from shotguns. In accordance with powder melt away amount charts it is extremely near 2400. Has everyone experienced any practical experience using this type of powder outside of loading shotgun shells?

I concur, Will not run off reaming everything till you've got loaded ample for being assured within your stack top.

The data supplied on this Site is for standard functions only and does not represent professional assistance. We make each and every effort and hard work to make sure the accuracy and dependability of the information, but we don't assurance its completeness or suitability for virtually any individual reason.




I get 1300 fps away from my H110 and like metallic cartridges it seems to complete much better in the higher speeds. Lil Gun functions but some say it decreases the hull life on account of burning the finishes of the hull

Include to estimate Only display this consumer #two · Jun 17, 2020 I have been working with H110 and don't love it. It's a ball powder along with the charge bar wants to adhere after a shell or two. Perhaps somebody will chime in on what they use.

Now Then again, Should the hulls are HS, then the powder bushing you need will have an ID of .296" and a focus on weight fall of 16.9grs, which should place the shell all around 1325fps, and that will pattern a hell of good deal better than just one at 1200fps isntead.

For this reason at 1200fps, the 410 with its long and slim shot column will sizzling spot center, even though the elevated velocity helps the center pellets to fill out the pattern, rather than very hot place centering isntead.

This is an more mature thread, you may not receive a reaction, and could be reviving an previous thread. find more information Be sure to consider developing a new thread.

Welcome to SGW. Because you are new right here, you may not have observed that you're looking at a 12 calendar year old thread. Nevertheless, Dano was logged on about five days back, so he may even see your submit and remedy your problem.




Incorporate to quote Only demonstrate this user #seven · Jun seventeen, 2020 I've browse around this site utilised lots of alliant410 and preferred it, I switched to h110 I do think Im getting better hull lifestyle Along with the h110. That said its a filthy powder the 410 was Significantly cleaner as well as the h110 does migrate a bit in my pw800plus even with the new spring loaded powder seal.

I can affirm from very first hand practical experience the 13gr. load works similar to a appeal having a load of three @ 0.395" balls; my loads were plastic shells but I see no motive why it wouldn't do the job with full size metallic shells.